STRUCTURE–PROPERTY RELATIONSHIP AND OPTIMAL FILLER CONTENT IN KAOLIN- AND GRAPHITE-FILLED EPOXY NANOCOMPOSITE COATINGS

Authors

  • Z.X. Jalolova Senior Lecturer, Department of Transport Logistics, Andijan State Technical Institute, PhD in Technical Sciences. Author

Keywords:

epoxy nanocomposite, kaolin filler, graphite filler, microhardness, optimal filler content, structure–property relationship.

Abstract

Determining the optimal filler content is one of the central practical problems in the design of filled epoxy coatings, since the same filler can either reinforce or weaken a composite depending on its concentration and dispersity. This paper analyses the microhardness behaviour of solar-cured epoxy nanocomposite coatings filled with four industrial kaolin grades (AKF-78, AKS-30, AKT-10, AKO) and mineral graphite, at filler contents ranging from 10 to 60 parts by mass, in order to identify the concentration range at which each filler yields the best mechanical performance. The data show that microhardness does not change monotonically with filler content: each filler type reaches a distinct maximum before declining, and the position of this maximum differs by up to 20 parts by mass between filler grades. The results are interpreted in terms of particle wetting, composition viscosity, and the specific surface area of the filler, and practical recommendations are given for selecting filler content in cast composite coatings.

References

1.Зиямухамедова У.А. Перспективные композиционные полимерные материалы на основе местных сырьевых и энергетических ресурсов. –Ташкент: «ТГТУ», -2011, -160 с.

2.Зиямухамедова У.А. Особенности структурной приспосабливаемости композиционных полимерных покрытий при взаимодействии их с хлопком, и технология их получения/ Автореф.док.дис, Ташкент, 2015. -28 с.

3.Ziyamukhamedova U. A. et al. Improvement of methods and means of testing non-conventional tribosystems //AIP Conference Proceedings. – AIP Publishing LLC, 2022. – Т. 2432. – №. 1. – С. 030031.

4.UA, Z., LY, B., EA, R., & Sh, B. B. (2019). Structure and properties of heterocomposite polymeric materials and coatings from them obtained by heliotechnological method.

5.Ziyamukhamedova U. A. et al. Improvement of methods and means of testing non-conventional tribosystems //AIP Conference Proceedings. – AIP Publishing LLC, 2022. – Т. 2432. – №. 1. – С. 030031.

6.Shcherbakov O. A. et al. ISNP/GNEIS facility in Gatchina for neutron testing with atmospheric-like spectrum //IEEE Transactions on Nuclear Science. – 2016. – Т. 63. – №. 4. – С. 2152-2158.

7.Bakirov L. R. Psychometric indicators of internet addiction of students-computer users //Neurology Bulletin. – 2015. – Т. 47. – №. 2. – С. 94-96.

8.Wang Y. et al. Exosomes as actively targeted nanocarriers for cancer therapy //International journal of nanomedicine. – 2020. – Т. 15. – С. 4257.

9.Razuvaeva E. V. et al. Structure and cytotoxicity of biodegradable poly (d, l-lactide-co-glycolide) nanoparticles loaded with oxaliplatin //Mendeleev Communications. – 2021. – Т. 31. – №. 4. – С. 512-514.

10.Yang C., Li Z. X., Xu J. T. Single crystals and two‐dimensional crystalline assemblies of block copolymers //Journal of Polymer Science. – 2022.

11.Sedush N. G. et al. Nanoformulations of Drugs Based on Biodegradable Lactide Copolymers with Various Molecular Structures and Architectures //Nanobiotechnology Reports. – 2021. – Т. 16. – №. 4. – С. 421-438.

12.Bakirov L., To‘ychiyev H. SELECTION AND FOUNDATION OF POLYMER BINDER-FILLER SUBSTANCES FOR HETEROCOMPOSITE POLYMER MATERIALS USED IN MACHINE-BUILDING //Science and innovation in the education system. – 2022. – Т. 1. – №. 5. – С. 34-39.

13.Jalolova, Zilola, and Shoxislom Rasulov. "MATERIALLARNING ISSIQBARDOSHLIK ME’ZONLARI VA ISSIQBARDOSH POLATLAR." Theoretical aspects in the formation of pedagogical sciences 1.5 (2022): 137-141.

Downloads

Published

2026-07-24